DIY Module for Flipper Phoenix

For enthusiasts and developers who prefer a hands-on approach, the Flipper Phoenix offers the opportunity to create a DIY version of the board. This section provides a comprehensive guide on how to craft your own version, ensuring you have all the tools and knowledge to bring your Flipper Phoenix to life.

Steps to Create Your DIY Version

First check the connections in UberGuidoZ (opens in a new tab)'s repository, especially for the ESP32 and NRF24/CC1101 modules.
Get all the hardware you need following this list
Install and wire everything (use 5V for the ESP32 and 3V for the extra module) in a prototyping board (opens in a new tab)

In this stage, your DIY version should look like the prototype version shown here or also the picture below:

Image Credits: knyghtryda (opens in a new tab)

Follow the guide to flash the firmware and FAPs.
Enjoy!

Tips for Success

Test different orientations and directions for your camera. The final design tilts the camera 90 degrees to the left.
If you aim to connect two external modules, replicate the pins for the ESP32 on another set of pins. However, modify the external module side as implemented in the latest version.

The DIY module section empowers users to craft their own Flipper Phoenix board, offering a blend of learning and innovation.

Compilation of the Firmware Firmware Mode